Spacare Bromide Salt 2,5 kg.

SpaCare Biobromide Salt must be dosed in the order of 650 g = 380 ml per. 500 l of water. We recommend that you dissolve the salt in a bucket of clean water and distribute the solution evenly in the bath water. Leave the water circulation running for at least 15 minutes, then start the bromine generator. Then measure the bromine content and pH frequently and add SpaCare SpaChock weekly to maintain the SpaCare Biobromide Salt content. Instructions for use: Start by reading the technical instructions from the spa manufacturer or the manufacturer of the electrolysis plant. Start-up procedure Check that the brake generator is switched off. Fill the spa to normal water level. Balances water pH: 7.2-7.8 and alkalinity: 80-120 mg / l. "Shock start" the water by adding 15 ml SpaCare Spachok per 500 l water. Then measure the water's TDS value and note the number for later use. Get help from your SpaCare dealer. Calculate how much BioBromide Salt should be in total. is added to your spa The dosage is: 650 g = 380 ml per 500 l of water To avoid overdose, first add 750 / o of the calculated amount. Dissolve the salt in a bucket of clean water and distribute the solution evenly in the bath water. Check TDS again. The correct value should be: 2000 mg / l higher than the TDS value measured above. Is the lower adjusted with extra Bio Bromide. The water circulation must be running and run for at least 15 min. after adding SpaCare BioBromide Salt to the water. The brake generator is started (on). Measure frequently, the following 2 days, the bromine content of the water and the pH value. Adjust the bromine generator to a bromine value in the water of 2.0-6.0 mg / l. Add SpaChock weekly to maintain the content of BioBromide Salt. BioBromide is hygroscopic and must be stored dry in tightly closed packaging.